Shifting
Adjusting shift lever
Slacken screw 1.
Turn foot piece 2 into desired
position.
NOTICE
A foot piece adjusted too high
or too low can cause problems
when shifting. In case of shifting
problems, check the adjustment
of the foot piece.
Tighten screw 1 to appropriate
torque.
Eccentric, peg to shift
lever
6 lb/ft (8 Nm)
Windshield
Adjust windshield
Switch on ignition (
When you pull away the wind-
screen automatically returns to
the position it was in before the
ignition was switched off.
Press button 1 at top to raise
windshield.
Press button 1 at bottom to
lower windshield.
Switch off ignition (
The windscreen automatically
moves to the bottom limit posi-
tion.
If the windscreen encounters
resistance before it reaches
43).
its limit position the pressure-
sensitive finger guard system
goes active. The windscreen
is stopped and raised slightly.
After a delay of a few seconds
the windscreen again attempts
to move to the bottom limit
position.
4
43).
71
z