BMW K 1600 GTL Exclusive Rider's Manual page 69

To deactivate the motion sen-
sor (for example if you are
about to transport the motor-
cycle on a train and the sway-
ing movement of the moving
train could trip the alarm), press
button 1 on the remote con-
trol again during the activation
phase.
Turn indicators are illuminated
three times.
Confirmation tone sounds three
times.
Motion sensor is deactivated.
Alarm
The alarm can be triggered by
the motion sensor
an attempt to use an unau-
thorized key to switch on the
ignition
disconnecting the alarm system
from the motorcycle battery
(alarm system battery takes
over the power supply - alarm
sound only, no illumination of
the turn indicators).
If the battery is discharged all
functions remain operational; the
only difference is that the alarm
cannot be set off if the system is
disconnected from the motorcy-
cle battery.
An alarm lasts for approximately
26 seconds. During the alarm,
an alarm tone sounds and the
turn indicators flash. The type of
alarm sound can be programmed
in the multifunction display.
You can cancel an alarm at any
time without deactivating the
anti-theft alarm by pressing but-
ton 1 on the remote control.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The anti-theft alarm system indi-
cator lamp then signals the rea-
son for the alarm for one minute.
The meanings of the flash codes
are as follows:
4
67
z