Dfs Alarm Installation - Pioneer DEH-P4100 Installation Manual

DFS Alarm Installation

CAUTION
• Because of the complexity of today's technically advanced vehicle wiring sys-
tems, we recommend that your DFS Alarm be installed ONLY by a professional
Pioneer installer.
Affix the included deterrent stickers to the inside of the front door windows.
Description
7 White/yellow (DOOR SWITCH) ........................................................................ (Fig. 3 & 4)
This lead is used to trigger DFS Alarm when any door is opened and may be connected to
either positive or negative (+/–) type door pin switches.
7 Brown (ALARM OUTPUT) ........................................................................................ (Fig. 5)
This lead is a pulsed positive (+) output capable of driving up to 2 relays (500 mA) max.
Use this lead to trigger relays for siren, horn, honk or flashing lights.
Door Switches
The DFS Alarm's door trigger input is designed to work with either positive or negative
door pin switches. After hookup, simply set door system type from DFS Alarm Setting
Menu.
Domelight Delay-DFS Alarm will wait for last door to close and courtesy light to turn off
before Exit Delay Timer Starts.
DOOR SWITCH (White/yellow)
Grounding Type Switch:
GM, Chrysler, Japanese, and most European vehicles.
Note:
• Set DFS Alarm to recognize ground trigger from DFS Alarm Setting Menu. Set Door System to
"DOOR-L :CLS".
This Product
Brown (refer to "ALARM OUTPUT".)
White/yellow
Fuse holder
Dome light
Factory Door Switches
Positive (Non-grounding) Type Switch:
Ford, Jaguar, Mercedes
Note:
• Set DFS Alarm to recognize positive trigger from DFS Alarm Setting Menu. Set Door System to
"DOOR-H :CLS".
Brown (refer to "ALARM OUTPUT".)
White/yellow
Dome light
Factory Door Switch
Fuse holder
Installing New Pin Switches
Fig. 3
Separately sold pin switches are available that can be used to protect your vehicle's trunk,
hood etc. When you purchase these, make sure that you first confirm that they can be used
with your vehicle's door system type.
Follow the makers instructions as to installation and wiring.
ALARM OUTPUT (Brown)
The brown lead provides a +12 V, pulsed output while alarm is sounding. This lead has a
maximum current capability of 500 mA and can be used to trigger a relay to sound a siren,
horn or flash lights.
Recommended Wiring:
30 amp relay (sold separately) required to operate siren, horn or lights.
• Connect Brown wire to one side of relay coil.
• Connect ground to other side of coil.
For sirens, horns or lights requiring +12 V trigger
This Product
• Connect normally open to fused, constant +12 V source.
For horns or lights requiring ground trigger
• Connect normally open pin to ground.
RELAY
(Sold separately)
30A Fuse
Fig. 4
(Sold separately)
30A
BATT
GND
≠ +
Car battery
<ENGLISH>
This Product
Brown
White/yellow (refer to "DOOR SWITCH".)
CONTROL
OUTPUT
Horn/Siren etc.
Fig. 5