Chapter 6 Maintain And Self Checlk; Caution In Maintenance; Self Check; Model Selection - Haier HW80-B1486 Service Manual

SERVICE MANUAL
HW80-B1486/HW80-B1286
6
6

6-2 Self check

1. How to start
Press the "Intense" and Pr ewas but ton, the np l ug on the m a ch i ne," tESt"will be displayed by tur
Press Start/Pause but ton , the mod e l of the machine wi l l be displayed( suchas 14 80).Pres
button again,the machine will start a self test program, then the following will be performed.
2. Test item
1) When the door switch is closed for three seconds, 88: 88
2) when the main wash valve allows water to let in for 5 seconds, when the prewash valve allows water to let in for
5 seconds, when the intenerate valve allows water to let in for 5 seconds, come into next water level, 7 7: 77 wil
be displayed, If the water can not reach the level in 2 minutes," Err5 " will be displayed. If the water exceeds the
overflow level, " Err8 " will also be displayed.
3) When the washing machine heats water for 10 seconds, 66:66 wi ll be displayed
4) When the washing machine drains for 2 minutes, if no w ater left , 5 5: 5 5 will be displayed
Otherwise " Err2 " will be displayed.
5) When the inner drum runs for ten seconds with the speed of 90 rpm at this time and for thirty seconds with the
speeds of 800rpm 44:44 will be displayed.
6) When the self check program is completed, "End" will be displayed.

6-3. Model selection

When the display board (on the control panel) is replaced technician need to select the correct model according with
the model name on the washing machine.
1 Press the Rinse button and then plug on the machinet the same time,Then 14 80 " will be displayed ont he screen
2 Press the S p e e d button t o choose correct speed
1680-1480--1470-1460-1280-1270-1260--1080-1070-1060 will be displayed by turn.
Then press the Tem p . b uttont save
For this model H W80 - B1486/ HW80- B1286 plea se choos
3 If you want to change the model again after storage, you can cut off the NTC and do the cycle adjustment.
Front Load Washing Machine
w ill be displayed . O ther wise"Err1"will be di splaye
1480 1280
11
s Start/Pause
l