Makita PV7000C Instruction Manual page 6

CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded,
resulting in tool malfunction.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or
the speed adjusting function may no longer work.
The tools equipped with electronic function are easy to
operate because of the following features.
Electronic constant speed control
•
Possible to get fine finish, because the rotating
speed is kept constant even under the loaded
condition.
Soft start feature
•
Soft start because of suppressed starting shock.
High-Low speed setting button
1
003444
The tool speed can be changed instantly while the tool
is running. Depress the "I" position for lowest speed and
depress "II" position for a given number setting.
The tool speed cannot be changed when the button is in
"I" position, even if you turn the speed adjusting dial.
When you turn the speed adjusting dial, always be sure
that the button is depressed in "II" position.
1. High-Low speed
setting button
6
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (auxiliary handle) & cover
1
2
004419
1
2
004420
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Install the cover, then screw the side grip on the tool
securely. The side grip and the cover can be installed
on either side of the tool.
Installing or removing backing pad
1
004421
Hold the spindle with the wrench so that it cannot
revolve. Then screw the pad onto the spindle all the way.
(The pad can be used to install the optional sponge
pad.)
To remove the pad, follow the installation procedure in
reverse.
1. Cover
2. Side grip
1. Cover
2. Side grip
1. Backing pad
2. Spindle
2
3. Wrench
3