Supplying Power - Panasonic Palmcorder PV-D300 Operating Instructions Manual

Supplying Power
I[1'] i P.JL:JJ,_ I | =1"_Jl :J_ | (:J iLVl ;['r4:1
Charge Battery Pack fully before use. j
POWER _ -
Lamp __ •
CHARGE J.j
2
Lamp
3
alt,err' Ct ,arng
Use this marker as a reminder to yourself
when the battery is fully charged or in need
of a charge. This marker performs no
function and is for your reference only.
BATTERY
PACK
C_CZ:3
Plug in AC Adaptor.
POWER Lamp lights.
Insert Batter3_.
O Align right side of Battery with line
on AC Adaptor.
_) Press Battery down and slide in
direction of arrow.
CHARGE Lamp lights and then goes
out when charging is done (approx.
1 hour).
Remove Battery
Slide Battery out and off.
• Battery life gradually decreases after
repeated use and recharging. If operation
time becomes very short even after a
sufficient charge, discard Battery properly
(page 11).
Note:
After recharging 5 times, use BATTERY
REFRESH feature as explained on page 11.
A fully charged Battery provides a maximum of about 1 hour 10 minutes of continuous
use. Actual time may vary due to operating conditions. Using the Built-in Light decreases
operating time.
2
1
2
Attach
Align Battery with top of mounting
surface.
_) Press and snap into place.
Remove Battery
While sliding _BATTERY RELEASE,
remove Battery.
10