Table of Contents
Advertisement
Supplying Power
Charge the Battery Pack
Charge Battery Pack fully before use
POWER
Lamp
CHARGE
Lamp
Note:
After recharging 5 times, use BATTERY
REFRESH feature as explained on page 10.
Plug in AC Adaptor.
POWER Lamp lights.
Insert Battery.
o
Align right side of Battery with line
on AC Adaptor.
© Press Battery down and slide in
direction of arrow.
CHARGE Lamp lights and then goes
out when charging is done (approx.
1 and 1/2 hours).
Remove Battery
Slide Battery out and off.
Battery life gradually decreases after
repeated use and recharging. If operation
time becomes very short even after a
sufficient charge, discard Battery properly
(page 10).
Use the Battery Pack
A fully charged Battery provides a maximum of about 2 hours of continuous use. Actual
time may vary due to operating conditions. Using the Built-in Light decreases operating
1
2
Attach Battery
© Align Battery with top of mounting
surface.
© Press and snap into place.
Remove Battery
While sliding
BATTERY RELEASE,
remove Battery.
9
Advertisement
Table of Contents
