Black & Decker SM700 Manual page 9

• Add the selected cutting disc (6) by
locating the 2 tabs (21) on the disc (6)
in the 2 slots in the Mincer body (22)
and the central hole over the boss on
the screw (8) (Fig. F).
• Screw the Mincer fastening dial (5) onto
the body to lock the parts in place.
• Place the Mincer body over the drive
coupling. Push the lock pin back &
rotate the body anti-clockwise. Once
the sprung-loaded pin aligns with the
recess in the Mincer body, the spring
will force it forward to lock the body in
place (Fig. G, H).
• Fit the Mincing tray (10) into the inlet
chute, aligning the rib in the chute with
the slot in the tray (Fig. I).
• Add ingredients to the tray.
• Connect the unit to a suitable supply.
The lamp around the power control will
flash.
• The ingredients can be guided into the
chute with the food pusher (11).
• The chute will guide the ingredients
onto the cutting disc where the blade
will cut it, allowing the cut pieces to be
forced through the holes in the disc.
• Once mincing is completed, return the
power control to the "OFF" position
and disconnect the appliance from the
electrical supply.
• Press the Mincer lock button (20)
release the Mincer body allowing it to
be rotated clockwise & lifted from the
unit.
Warning! Do not operate the mincer for
more than 6 minutes continuously at a time.
Warning! Keep hands, long hair and loose
clothing away from moving parts.
(Original instructions)
Using the mixer (Fig. J, K, L)
• Clean the beaters, dough hooks, whisk
and bowl before use.
• Place the appliance on a flat, steady
surface.
• Ensure that the power cord is
unplugged from the power outlet and
the speed selector (4) is set to the "0"
position.
• Make sure the Blender cover is locked
in place. When correctly located, the
cover operates a micro-switch. If the
cover is not fitted, the appliance will not
operate.
• Place the bowl (2) in the recess in the
stand & rotate it clockwise to lock it in
place (Fig. J).
• Press the pivot release button (3) &
raise the motor housing until it locks in
place (Fig. K).
• Lifting the housing will release the
micro-switch to prevent the appliance
working while the housing is raised.
• Push the whisk (13), dough hook (14) or
beater (12) onto the Mixer drive shaft (1)
and rotate it clockwise to lock it in place
(Fig. L).
• Beaters are for mixing egg white or
other liquid, dough hooks are for
kneading dough, whisk is for Light
mixtures e.g. Cream, eggwhites,
blancmange etc.
• Add the ingredients to the bowl.
• Press the pivot release button (3) and
lower the motor housing until it locks in
place.
ENGLISH
9