Cleaning And Maintenance - Black & Decker SM700 Manual

ENGLISH
• Lowering the housing will close the
micro-switch, allowing the appliance to
work.
• Once the motor housing is lowered,
additional ingredients may be added
through the hole in the splash guard
without raising the housing again.
• Connect the unit to a suitable supply.
The lamp around the power control will
flash.
• Rotate the rotary power control (4) to
the required setting The lamp will stop
flashing but stay lit.
• Once mixing is completed, return the
power control (4) to the "OFF" position
and disconnect the appliance from the
electrical supply.
• Press the pivot release button (3) and
raise the motor housing until it locks in
place.
• Remove the mixing attachment by
pushing it up and rotating it anti-
clockwise.
• Remove the bowl (2) by rotating it anti-
clockwise and lifting it from the stand.
Warning! Do not place knives, spoons,
forks or any other object into the bowl
while operating.
Note! The maximum operation time must
not exceed 10 minutes. After 10 minutes of
use allow the mixer to rest and cool for an
appropriate amount of time.
• When Kneading dough, best results
can be achieved by setting the speed
selector at a low speed first and then
high speed.
Note! During operation do not touch the
bowl.
10
(Original instructions)
Warning! Keep hands, long hair and loose
clothing away from the beaters.
Cookery tips
• Refrigerated ingredients, such as
butter and eggs, should be at room
temperature before mixing begins. Set
these ingredients out ahead of time.
• To eliminate the possibility of egg shells
in your recipe: break eggs into separate
container first, then add to the mixture.
• Do not over-beat. Be careful that
you only mix/blend mixtures as
recommended in your recipe. Fold dry
ingredients until they are just combined
using the low speed setting.
• Climatic conditions. Seasonal
temperature changes, temperature of
ingredients and their texture variation
all play a part in the required mixing
time and the results achieved.
• Always start mixing at lower speed.
Gradually increase to the recommended
speed as stated in the recipe.
• For "Pulse" setting (kneading at short
intervals), turn the speed knob to the
"Pulse" position. The appliance works
only if the speed knob is maintained in
this position, when the knob is released
,it returns automatically to the "0"
position.

Cleaning and maintenance

Warning! Before performing any
maintenance:
• Switch off and disconnect from the
mains supply.
• Wait for the appliance to completely
cool down.