Black & Decker SM700 Manual page 8

ENGLISH
Warning! Do not fill the blender jar with hot
ingredients more than 80°C.
Warning! To prevent spilling, do not put
more than 1.5 litres of liquid in the blender
jar. According to your requirement, the
ingredients should include less than 600g
of solid foodstuffs and less than 900g of
liquids at a time.
• Connect the unit to a suitable supply.
The lamp around the power control will
flash.
• Set the speed selector (4) to the
required setting.
• Once Blending is completed, return the
power control to the "OFF" position
and disconnect the appliance from the
electrical supply.
• Rotate the jar anti-clockwise and lift it
from the appliance (Fig.C).
• Remove the lid & pour the ingredients
into a suitable container.
Warning! Never remove the lid while the
blender is running.
Warning! Do not remove the lid from the
blender jar during use with ingredients in it.
Warning! Do not operate the blender for
more than 2 minute periods.
Note: The opening of the lid can be used
to add ingredients while the appliance is
running. Please remove the measuring cup
from the lid to do so.
• It may be necessary to switch off the
appliance from time to time to remove
pieces of food sticking to the inside of
the blender jar.
• Switch off the appliance and unplug it.
8
(Original instructions)
• Remove the measuring cup and the lid.
• Remove pieces sticking to the inside of
the blender jar with a soft spatula.
• Keep the spatula at a safe distance from
the blades.
Using the mincer (Fig. D, E, F, G, H, I)
Cut all foods into pieces. Sinewless,
boneless and fatless beef or pork is
recommended, approximate size : 20 mm x
20 mm x 60 mm so that they fit easily into
the hopper opening.
The ingredients should avoid bone or hard
substances, as these could cause the motor
to seize. If the motor seizes, please turn off
the appliance and disconnect it from the
power supply.
Disassemble the mincer and remove the
bone or hard material. After the motor has
cooled down, the function should restore.
• Clean the mincer components.
• Place the appliance on a flat, steady
surface.
• Make sure the Blender cover (18) is
locked in place. When correctly located,
the cover operates a micro-switch. If the
cover is not fitted, the appliance will not
operate.
• Push the Mincer cover (19) up & remove
it from the appliance (Fig. D).
• Select the required Mincing disk fine,
medium or coarse (6) (Fig. E).
• Fit the Mincer screw (8) into the Mincer
body (9) (Fig. F).
• Place the blade (7) over the square on
the screw shaft (8) (Fig. F).