Advertisement
!
WARNING
•Study, understand, and follow all instructions
provided with and on this device before operating this
device.
•Do not exceed rated capacity.
•This is a lifting device only.
•After lifting, immediately transfer the load to
appropriately rated vehicle stands.
•Never work on, under, or around a load supported by
this device.
•Use only on hard, level surfaces capable of
sustaining rated capacity loads.
•Do not move or dolly loads with this device.
•Do not modify this device.
•Do not use adapters or accessories that are not
provided initially.
•Lift only on areas of the vehicle as specified by the
vehicle manufacturer.
•Failure to heed these markings may result in
personal injury and/or property damage.
ASSEMBLY
EQUIPMENT NEEDED FOR ASSEMBLY:
1. Needle nose locking pliers
2. Snap-ring pliers (for: HW93657 and HW93667 only)
3. 15 /16" wrench (for: HW93660 and HW93662 only)
4. Hammer
5. Tape measure
6. All necessary hardware is included and is assembled loosely onto the jack
ASSEMBLY INSTRUCTIONS:
1. Remove the service jack base and handle from the carton.
2. For HW93657and HW93667, see figure 1 to remove the retaining ring and the handle pivot pin from the jack base that
connects through the handle fork. For HW93660 and HW93662 (as shown in figure 2) remove the 5/16-18 bolts and
the pin from the jack base that connects through the handle fork.
3. Remove the #6-32 screw and nut from the universal receptacle on top of the hydraulic unit.
4. Pull the universal assembly, located on the bottom of the handle, out a minimum of 1-3/4".
5. Clamp the needle nose locking pliers onto the rod so that the universal assembly will not retract back into the handle.
6. Slide the universal assembly into the handle socket so that it extends out the other side.
7. Push the pivot pin that was removed in step 2 back through the handle and handle socket (may have to gently tap the
pin with a hammer).
8. Align the pivot pin with the holes on the side plates that the pivot pin was removed from and tighten the 5/16"-18 bolts
into the pivot pin until secure. (for HW93660 and HW93662 only)
9. Connect the universal assembly to the universal receptacle rod using the #6-32 screw and nut from note 3 (finger
tighten only).
10. Remove the needle nose locking pliers.
11. Jack is now operational and ready for use.
Helpful hint:
If the jack cover is a hindrance, it can be removed by using a 1/8" punch and taping out the pivot pins (be sure to attach
the cover back to the jack after assembly is completed).
!
WARNING
To avoid crushing and related injuries:
NEVER work on, under or around a load supported
only by a jack. ALWAYS use adequately rated jack
stands. Immediately transfer the load to adequately
rated jack stands.
Be sure all tools and personnel are clear before lowering
load. No alterations shall be made to this device. Only
attachments and/or adapters supplied by the manufac-
turer shall be used. Lift only on areas of the vehicle as
specified by the vehicle manufacturer.
Advertisement
