Raise Lights - AeroGarden Cherry Tomato Manual

Raise Lights

As your plants begin to grow, leave approximately 1-2 inches
of space between the top of plants and the lights.
To raise the lights:
Unplug the AeroGarden (the
1
backup system will save your
settings).
Carefully remove the Bowl from
2
the Base and set aside.
Turn the AeroGarden around
3
so the back of the Lamp Arm is
facing you.
Firmly hold the lower section of
4
the Lamp Arm and push in the
Locking Button on the Arm. With
your other hand, grasp the silver
ring at the top of the Arm (where
the Lamp Hood attaches to the
Arm). Pull up firmly on Lamp
Hood until the Locking Button
becomes visible in the next hole.
Move Locking Button up only
one hole at a time. The lights need to be close to the plants for
optimal light intensity.
5 Replace the Bowl on the Base
and plug in your AeroGarden.
6 Lift the View Door to check that
the water is flowing. If not, refer
to Troubleshooting on page 33
of this guide.
11
Tending Your Garden
Lamp
Hood
Locking
Button
If the Grow Bulbs are too
close to the plants, the
leaves may brown and burn.
!
If they are too far away, your
plants will "stretch" towards
the light and look floppy
and unhealthy.
Base
Bowl
Lamp
Arm