White Balance - Panasonic NV-DS60 Operating Instructions Manual

ª White Balance
≥You cannot change White Balance if you set
[EFFECT] of [DIGITAL EFFECT] Sub-Menu on
the [CAMERA FUNCTIONS] Main-Menu to
[GAIN UP] and Colour Night View Function.
≥You cannot use the Manual White Balance
Adjustment when the zoom magnification is
approximately 10k or higher.
In the following cases, the [1] Indication
flashes:
≥The flashing indicates that the previously
adjusted White Balance setting is still kept. This
setting will be kept until White Balance is
adjusted again.
≥You may not be able to achieve correct White
Balance Adjustment manually under weak
illumination.
ª Manual Shutter Speed Adjustment
≥You may see vertical lines of light in the playback
image of a brightly shining subject or highly
reflective subject.
≥During normal playback, movement in the
images may not look smooth.
≥Because the colour and brightness of the
playback image may become unstable, avoid
recording under fluorescent light, mercury light,
or sodium light.
≥If you are using Gain-up Mode (l 28), Colour
Night View Functon (l 23) or Programme AE
Mode (l 24), you cannot adjust the shutter
speed. If the shutter speed was adjusted
manually, this setting will be cancelled.
≥When [PROGRESSIVE] is set to [ON], the
shutter speed cannot be adjusted to 1/750 s or
faster.
ª Manual Iris Adjustment
≥If you are using Programme AE Mode (l 24),
you cannot adjust the iris. If the iris is adjusted
manually, this setting will be cancelled.
≥If you attempt to adjust the Shutter Speed after
setting the Iris, the value set for the Iris will be
cancelled.
ª Digital Effect Functions
≥When you set the following functions, [EFFECT]
will be set to [OFF].
≥Progressive Photoshot Function
[PROGRESSIVE] (l 20)
≥Digital Zoom [D.ZOOM] (l 21)
≥Image Stabilizer Function [SIS] (l 22)
It is as follows when [GAIN UP] is
selected.
≥The shutter speed cannot be operated.
≥White Balance cannot be changed.
48
≥The Sports Mode [5], the Portrait Mode [7]
and Low Light Mode [4] are cancelled.
Wipe Mode and Mix Mode
If either one of the following operations is carried
out, stored images will be erased, and Wipe and
Mix Functions cannot be used.
≥Record with Photo Title Function.
Picture-in-Picture Mode
≥If the Movie Camera is turned off, the smaller
picture disappears.
≥The position of a small picture is fixed at the
bottom right of the screen.
ª Playing Back
Repeat Playback
If you continue to press the [1] Button for
5 seconds or longer, the Movie Camera switches
to Repeat Playback Mode, and the [R !]
Indication appears. (To cancel Repeat Playback
Mode, set the [VCR/OFF/CAMERA/M-CARD]
Switch to [OFF].)
Listening to Playback Sound through
Headphones
When you wish to listen to playback sound
through headphones, connect the headphones to
the [PHONES] Socket (l 7) on the Movie
Camera. In this case, no sound (including a
warning sound and shutter sound) will be
reproduced through the built-in speaker of the
Movie Camera.
Multi-Picture Mode
≥The quality of Multi images deteriorates slightly.
≥Playback Multi-Mode screens cannot be output
through the DV Terminal (l 37) or Digital Still
Picture Terminal (l 7).
≥If there is input from DV Terminal, a multi screen
cannot be created.
ª Index Search Functions
≥Index Search may not be possible at the
beginning of tape.
≥Because Photoshot Index Signals are not
recorded on still pictures recorded in Continuous
Photoshot Mode, the Photoshot Index Search
Function cannot be used for these still pictures.
≥Scene Index Search may not function properly if
the interval between 2 scene index signals is
shorter than 1 minute.
ª Playback Digital Effect Functions
≥When [EFFECT1] on the [DIGITAL EFFECT]
Sub-Menu is set to [TRAIL], the digital modes of
[EFFECT2] cannot be used.
≥Signals of images to which digital effects are
added during playback cannot be output from
the DV Terminal (l 7) or Digital Still Picture
Terminal (l 37).