Ps10 Guided Tour - Front Panel - Samson PowerStrip PS10 Owner's Manual

PS10 Guided Tour - Front Panel

1
PowerStrip PS10 Front Panel
1: Circuit breaker- This circuit breaker will trip whenever the total load on the PS10
(all rear panel switched outlets plus the front panel unswitched convenience
outlet) exceeds 10 amps. To reset it, unplug one or more devices so as to reduce
the load and gently press the circuit breaker in until you hear it click.
Note: It may take a minute to cool before you can reset it.
2. Vent - Convection cooling is accomplished by the front panel vent holes.
3: Unswitched convenience outlet- This IEC outlet is active whenever the PS10 is
plugged in, regardless of the setting of the Outlets switch (see #4 below).
4: Outlets switch- Use this to turn the rear panel outlets on or off. When on, the
status light inside this switch is lit red.
2
4
3 4