Pb10Pro Guided Tour - Front Panel - Samson PowerStrip PS10 Owner's Manual

PB10PRO Guided Tour - Front Panel

1 2
PowerBrite PB10Pro Front Panel
1: Circuit breaker- This circuit breaker will trip whenever the total load on the
PB10Pro (all rear panel switched outlets plus the front-panel unswitched
convenience outlet) exceeds 10 amps. To reset it, unplug one or more devices so
as to reduce the load and gently press the circuit breaker in until you hear it click.
Note: It may take a minute to cool before you can reset it.
2: Dimmer - Use this to adjust the level of the LED light in the slide out Lamps.
3: Lamps- Contains the PB10Pro's 5-LED light. Use the Dimmer control (see #2
above) to turn the light on or off. To turn off the lamp, gently slide the lamp back
in.
4: Voltmeter- This three digit LED meter shows the amount of voltage in the
electrical signal being received by the PowerBrite PB10Pro.
WARNING: Severe voltage swings can cause damage to connected
equipment. If you see the voltmeter changing drastically or rapidly,
disconnect the PB10Pro until the source of the problem is identified.
5: Vents- Convection cooling is accomplished by the front panel vent holes.
6: Ammeter- This three digit LED meter shows the amount of current being drawn
by equipment connected to the PB PB10Pro.
WARNING: Severe current swings can cause damage to connected
equipment. If you see the ammeter changing drastically or rapidly,
disconnect the PB10Pro until the source of the problem is identified and
repaired.
7: Unswitched convenience outlet- This IEC outlet is active whenever the PB10Pro
is plugged in, regardless of the setting of the Outlets switch (see #8 below).
8: Outlets switch- Use this to turn the rear-panel outlets on or off. When on, the
status light inside this switch is lit red.
3 4 5 6
8
3 7 8