Toro 22295 Operator's Manual page 8

3. Set the machine to the desired cutting height; refer to
Adjusting the Cutting Height (page
4. Route the control cables between the deck and the
handle to protect the cables from being damaged
(Figure 4).
Figure 4
1. Cable guard
2. Handle
5. Stand in the operating position to determine the handle
height that is most comfortable for you
Figure 5
1. Handle
2. Handle bracket (2)
3. Highest handle height
6. Secure the handle onto the handle brackets at your
desired handle height with 2 carriage bolts (5/16 x
1-1/2 inches) and 2 flange nuts (5/16 inch) as shown
in Figure 6.
12).
3. Cable(s)
(Figure 5).
4. Medium handle height
5. Lowest handle height
Important: Ensure that the bolt heads are on the
inside of the handle and that the nuts are on the
outside of the handle.
1. Carriage bolt—5/16 x
1-1/2 inches (2)
2. Handle bracket (2)
7. Position the cable guard onto the handle with the
cable(s) inside the guard, and secure the guard to the
handle with the 2 carriage bolts and the 2 locknuts that
you previously removed
Important: Ensure that you do not pinch the
cable(s) to the handle when you install the cable
guards onto the handle.
8
Figure 6
3. Flange nut—5/16 inch (2)
(Figure 3).