Installing Batteries In The Remote Control; External Connection; Antenna Connection - Kogan Essendon User Manual

General Description

Installing Batteries in the Remote Control

1 Open the battery compartment
cover on the back side.
2
Insert two 1.5V AAA size batteries
in correct polarity. Don´t mix old or
used batteries with new ones.
3
Close the cover.
The batteries (battery pack or batteries installed) should not be exposed to excessive
heat such as sunshine, fire or the like.

External Connection

Antenna connection

Antenna input impedance of this unit is 75ohm. VHF/UHF 75ohm coaxial cable can be
connected to the antenna jack directly, if the antenna cable is 300ohm parallel flat feeder
cable, you need to use the 300ohm/75ohm converter to connect the antenna cable to the
antenna jack. For details Please refer to the following drawing.
Antennas with 300 W
Use a 75ohm - 300ohm converter
300ohm coaxial cable
Installing Batteries
flat twins Leads
ANT IN
Antenna feeder
Point the remote towards the remote
control sensor of the TV and use it
within 8 meters.
Put the used batteries into the recyc-
ling bin since they can negatively
affect the environment.
Antennas with 75 W
75ohm coaxial cable
16
Round Leads
Antenna cable