Advertisement
menu of the monitor) to optimize the image on the system monitor.
7. Remove the tinted dome cover by pressing and pulling.
8. Hold the Dome camera at the proposed installation position.
9. To make sure the image on the monitor is the right way up.
Case a (ceiling mount): Make sure the lens is pointing away from the
Philips logo, before rotating it into the preferred direction.
Case b (wall mount): Make sure the lens is pointing at the Philips logo
before rotating it into the preferred direction.
Note: When the minidome camera is unpacked, the default position of the
camera image is with the top of the image at the Philips' logo side.
10. Check the monitor to ensure the Dome camera covers the required area. (The
best results are obtained when the Dome camera is not looking into a bright
light source).
Eng
11 If necessary adjust the focus ring of the integrated Dome camera lens to obtain
optimal image sharpness .
Caution: Never touch the glass of the camera lens as this may cause damage.
12. Fit the tinted dome cover.
Field of view
The figure below shows the Field of view
Dome camera sound on/off
Use the On Screen Display Menus of your system monitor to enable or disable the
built-in Dome camera microphone.
6
Advertisement
