[JAM error]
2-2
Paper feed jam
• Does a paper feed jam occur when the power supply is turned on?
• Yes
• Yes Remove the jammed paper.
• No
• No Replace paper sensor E (exit or paper).
• Yes
• No
Has the paper arrived at paper sensor E (paper)?
• No
• No Check the gear block.
• Yes
• No Set the EP unit correctly.
• Yes
• Yes
Has the paper arrived at the paper sensor (exit)?
• Yes
• No Replace the paper sensor (exit).
• Yes
• No
Check the gear block.
2-3
Paper exit jam
• Does a paper exit jam occur when the power supply is turned on?
• Yes
• Yes Remove the jammed paper.
• No
• No Replace the paper sensor (exit).
• Yes
• No
Check the gear block or replace the eject roller.
Is the jammed paper on paper sensor E (paper/exit)?
Is paper sensor E (exit/paper) operating normally?
Replace the high-voltage power supply board.
Is the feed roller rotating?
Is the EP unit set correctly?
Check the gear block.
Is the paper sensor (exit) operating normally?
Replace the high-voltage power supply board.
Is the jammed paper on the paper sensor (exit)?
Is the paper sensor (exit) operating normally?
Replace the high-voltage power supply board.
6 - 10