Advertisement
5. Lamp installation or replacement
• Always switch off the mains supply before installing or replacing the lamp. never try to
replace the lamp when it is hot.
• Do not touch the bulb with bare hands. If this does happen, clean the lamp with denatured
alcohol and wipe with a lint free cloth before installing.
WT-CUB-HID
1. Loose the screws on the housing cover.
2. Loose the screws of the lamp wire from terminator
3. Take out the old lamp and replace the new one to the fixture.
4. Connect the lamp wire to the terminator as before.
5. Please reinstall step 2 and step 1.
WT-KLD-HID
6-
6. Beam angle
The Projector is best to be placed 5 meters from wall, and from this distance the light effect
will cover an area of 3.7 m x 3.7 m.
7. Troubleshooting
Probable cause(s)
Problem
No power to the fixture
Blown fuse
No light
Burned out lamp
Fixture too hot
Sound too low to activate
control circuit
No action
Electrical malfunction
Suggested remedy
Check power connections
If power is applied but does not
light, please check and replace
fuse if necessary.
Install new lamp.
Allow to cool down. Improve air-
flow around the unit.
Increase volume.
Refer to service technician.
7-
Advertisement
