Advertisement
1. Introduction
Thank you for purchasing Wild Tech's Cubist and Kaleido.
WT-CUB-HID
Cubist is a great 3D high precision optical effect with 12 patterns, delivering
amazing lighting shows. Comes with great built-in programs with auto movement or sound
activation, ideal for discos, pubs, parties, etc.
WT-KLD-HID
Kaleido is a unique 150W kaleidoscopic effect that projects a swarm of
swirling patterns. Comes with great built-in programs with auto movement or sound
activation. It's linkable, performing synchronized light show, perfect for discos, clubs, bars,
and parties.
2. Safety Instruction
Please read carefully the instruction, which includes important information
about the installation, usage and maintenance.
WARNING
♦
Please keep this User Guide for future consultation. If you sell the unit to another user,
be sure that they also receive this instruction booklet.
♦
Unpack and check carefully there is no transportation damage before using the unit.
♦
Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.
♦
It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
♦
The unit is for indoor use only. Use only in a dry location.
♦
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
♦
Disconnect mains power before fuse/lamp replacement or servicing.
♦
Replace fuse/lamp only with the same type.
♦
Make sure there is no flammable materials close to the unit while operating as it is fire
hazard.
♦
Use safety cable when fixes this unit.
♦
Maximum ambient temperature is TA: 40℃. Don't operate it where the temperature is
higher than this.
2-
♦
Unit surface temperature may reach up to 85℃. Don't touch the housing bare-hand
during its operation. Turn off the power and allow about 15 minutes for the unit to cool
down before replacing bulb or serving.
♦
In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage
or malfunction. Please contact the nearest authorized technical assistance center.
Always use the same type spare parts.
♦
Don't connect the device to any dimmer pack or power pack.
Do not touch any wire during operation as high voltage might be causing
♦
electric shock.
Warning
♦
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
♦
Never touch bulb with bare fingers as it is very hot after using.
♦
Hot lamp explosion hazard. Do not open the unit within five minutes after switching off.
♦
Do not start on the unit without bulb enclosure or housing are damaged.
♦
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly
damaged.
♦
Do not look directly at the light while the bulb is on.
Caution
There are no user serviceable parts inside the unit. Do not open the housing or attempt
any repairs yourself. In the unlikely event your unit may require service, please contact
your nearest dealer.
Rigging the fixtures
The unit should be mounted via its screw holes on the bracket. Always ensure that the
unit is firmly fixed to avoid vibration and slipping while operating. Always ensure that the
structure to which you are attaching the unit is secure and is able to support a weight of
10 times of the unit's weight. Also always use a safety cable that can hold 12 times of the
weight of the unit when installing the fixture.
The installation must be carried out by qualified service people only. The device should
be installed out of reach of people and outside areas where persons may walk by or be
seated.
3-
Advertisement
