Advertisement
USER MANUAL
Resetting After an Alarm
One of four reset modes may have been programmed by your engineer.
Any Code
The system will reset the next time Any Code is used to set the system.
Master Code
The system will only reset if the Master Code or Engineer code is used to set the sys-
tem.
Engineer Code
The system will only reset if the Engineer Code is used to set the system.
Anti-Code
The system may only be reset by use of an Anti-Code obtained from your engineer or
central station.
To Reset System:-
Enter Code of correct type (see above).
Proceed to set the system.
If a set is not required re-enter the code to abort setting.
To Reset by Anti-Code:-
Make a note of the digit code given by the display when you try to set the system.
Contact your engineer or central station as instructed by the installation company and
give them the four digit number given by the display.
The resulting Anti-Code given by them is then entered into the Control Panel to reset it.
Note: This resulting code may also use the YES and NO keys.
Page 10
Advertisement
