Wiring Procedure - Panasonic CY-RC50KN Operating Instructions Manual

Wiring procedure

When connected to a Panasonic Car Monitor etc., the image from the camera is automatically
displayed in the screen when the shift lever is moved to reverse (R).
For some combinations of vehicle type and device, additional cords (option) may be
required, or connection may not be possible.
Consult your dealer or service centre.
For connection with products from other companies, consult the manufacturer of each
device.
Power connector (POWER)
Camera input (CAMERA IN)
Video output (VIDEO OUT)
CAMERA
POWER
IN
Power cord
(5 m)
Rear view camera
(4 m)
Ground lead
(Black)
Reverse lead
(Violet/white stripe)
1 A
Fuse 1 A
Note:
Insert connectors securely. Also, take care to avoid pulling on the cords.
Do not extend the RCA cord or rear view camera cord, as video noise and breakdowns could
result.
Only use clip connectors in the specifi ed places.
VIDEO
OUT
Rear view camera
control unit
(Yellow)
RCA cord
(Yellow)
(6 m)
GND
REVERSE
Make connections and set and operate acco
Always wear gloves for safety during
wiring and mounting operations.
Installation procedure
Disconnect the battery
Make wiring connections.
To avoid short circuit accidents, do not
connect the power cord connectors until all
wiring is complete.
Mount the components.
Reconnect the battery
To camera image input terminal or video
input terminal
NTSC Only
To a metal part of the vehicle body
Connect to an area of exposed metal, not
covered with paint etc.
To the wire of the reverse lamp
Do not connect to a point that has a
constant power supply.
terminal.
terminal.