Rear Panel Controls & Connectors (Vma260 & Vma2120) - JBL VMA160 Operation Manual

1.4 Rear Panel Controls & Connectors
A
Apparatet må tilkoples jordet stikkontakt CAUTION
Apparaten skall anslutas till jordat uttag
RISK OF ELECTRIC SHOCK
Laite on liitettävä suojakoskettimilla
DO NOT OPEN
varustettuun pistorasiaan
CAN-ICES-3(B)/NMB-3(B)
OUTPUTS
CH1
100V 70V COM
CH2
CLASS 2 OUTPUT WIRING PERMITTED
A. Amplifier output connectors.
B. Remote volume connectors – RJ-45 style connector to connect to JBL CSR-V
control modules.
C. Input 2 – Input audio through either the Euroblock connector or the 1/4" TRS
connector. Pins 4 and 5 of the Euroblock are priority contacts that will duck other
channels during an announcement when the contacts are closed using a switch.
D. Input 3 accepts input through either the 3-pin Euroblock or the Dual RCA jacks.
Stereo, unbalanced sources will be summed into a mono signal.
E. Music1 input uses a Dual RCA Connector. Stereo, unbalanced sources will be
summed together.
F. Input 5 – Input audio through either the Euroblock connector or the 1/4" TRS
connector. Pins 4 and 5 of the Euroblock are priority contacts that will duck other
channels during an announcement when the contacts are closed using a switch.
G. Input 6 accepts input through either the 3-pin Euroblock or the Dual RCA jacks.
Stereo, unbalanced sources will be summed together.
H. Music2 input uses a Dual RCA Connector. Stereo, unbalanced sources will be
summed together.
I. Signal Routing DIP switch is used to route inputs to both output channels. By
default, each group of inputs is routed only to its respective output channel (Input
1 – Music1 are routed to output CH1, Input 4 – Music2 are routed to output CH2).
J. VOX sensitivity adjustment for Input 1.
K. CH1 Settings DIP switch is used to enable the 70V/100V output option, turn on
the chime feature, select input gain, and enable phantom power for CH1.
L. VOX sensitivity adjustment for Input 4.
M. CH2 Settings DIP switch is used to enable the 70V/100V output option, turn on
the chime feature, select input gain, and enable phantom power for CH2.
N. AC Power Inlet – Detachable IEC.
B C D
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION
INPUT1 INPUT2
IS SUBJECT TO THE FOLLOWING CONDITIONS:
1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. FRONT
PANEL
REMOTE (CSR-V)
CH1 CH2
WARNING PRIORITY
- TO REDUCE
THE RISK OF FIRE OR
1-Input 1 to CH2
ELECTRICAL SHOCK, DO NOT
2-Input 2 to CH2
EXPOSE THIS EQUIPMENT TO
3-Input 3 to CH2
RAIN OR MOISTURE.
CH1 VOX
AVERTISSEMENT 4-Music 1 to CH2
-
(Input 2)
RISQUE DE CHOC 5-BT/USB to CH2
6-Input 4 to CH1
ÉLECTRIQUE - NE PAS
OUVRIR. 7-Input 5 to CH1
AVERTISSEMENT
8-Input 6 to CH1
-
ÉNERGIE ÉLECTRIQUE 9-Music 2 to CH1
CONTAINS FCC ID: API-MB8811VMA
DANGEREUSE VOIR LA 10-Not Used
CONTAINS IC: 6132A-MB8811VMA
NOTICE DE
CMIIT ID: 2016DJ2940
FONCTIONNEMENT. OFF ON
J
I K
Figure 1.4.1 Rear Panel - VMA 260
(VMA260 & VMA2120)
E
F
INPUT3 MUSIC1 INPUT4 INPUT5
FRONT
PANEL
MONO MONO
PRIORITY
SUM SUM
OFF ON
1-70V/100V Output
2-Chime OFF ON
3-Input 1 Line/Mic LINE MIC
CH2 VOX
4-Input 2 Line/Mic LINE MIC
(Input 5)
OFF ON
5-Input 2 Phantom
6-Input 3 Line/Mic LINE MIC
7-Input 3 Phantom OFF ON
8-Not Used NC NC
CONFORMS TO
HARMAN INTERNATIONAL UL STD .60065
1718 W. Mishawaka Rd., CERTIFIED TO CSA STD.
MADE IN CHINA
Elkhart, IN 46517 C22.2 NO .60065
L
G H
INPUT6 MUSIC2
220V-240V ~
50/60Hz
MONO MONO
SUM SUM
OFF ON
1-70V/100V Output
2-Chime OFF ON
3-Input 4 Line/Mic LINE MIC
4-Input 5 Line/Mic LINE MIC
ATTENTION - POUR RÉDUIRE LE
OFF ON
5-Input 5 Phantom RISQUE DE CHOCK ÉLECTRIQUE, LA
6-Input 6 Line/Mic LINE MIC FICHE CENTRALE DE LA PRISE DOIT
ÊTRE BRANCHÉE POUR MAINTENIR
7-Input 6 Phantom OFF ON
LA MISE À LA TERRE.
8-Not Used NC NC
CAUTION - TO REDUCE THE RISK OF VMA 260
ELECTRIC SHOCK, GROUNDING OF
THE CENTER PIN OF THE PLUG MUST
BE MAINTAINED.
M N
100V ~
120V ~
175W
9