Base Unit Settings; Base Unit Ringer Volume; Base Unit Ringer Tone; Base Unit Interrupt Tone - Panasonic KX-TG5453 Operating Instructions Manual

Programmable Settings

Base unit settings

Base unit ringer volume

4 levels (high/medium/low/off) are
available. The default setting is HIGH.
Important:
L Make sure the base unit is not being
used.
Press {<} or {>} repeatedly to select the
desired volume.
L To stop ringing, press {STOP}.
To turn the ringer off, press and hold {<}
until the unit beeps 2 times.
O
L " " will be displayed.
Note:
L When the ringer volume is set to off, the
base unit will not ring for outside calls
and it will ring at the low level for
intercom calls.
L When the ringer volume is set to off, the
base unit will not announce caller names
(page 26).

Base unit ringer tone

You can change the base unit ringer tone
heard when an outside call is received.
There are 3 tones and 4 melodies. The
default setting is "Tone 1".
This feature must be set by using the
handset.
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press {>}.
3
Scroll to "Set base unit" by pressing
{V} or {^}, then press {>}.
4
Scroll to "Ringer tone" by pressing
{V} or {^}, then press {>}.
42
For assistance, please call 1-800-211-PANA (7262).
5
Press {V} or {^} repeatedly to select
the desired setting.
L You can also select the ringer tone by
pressing {1} to {7}.
L If the ringer volume has been turned
off, the base unit will not ring.
6
Press {Save}, then press {OFF}.
Note:
L If you subscribe to a distinctive ring
service (such as IDENTA-RING), select
a tone (Tone 1 to 3). If you select a
melody, you will not be able to
distinguish lines by their ringers.
L If you select one of the melody ringer
patterns, the ringer will continue to
sound for several seconds if:
– the caller hangs up before you answer
the call.
– another person answers the call using
another phone connected on the
same line.

Base unit interrupt tone

This tone lets you know when you receive
a call while you are on an intercom call
(page 31).
"2" (default): The tone will sound 2 times.
"On": The tone will sound for as long as the
line rings.
"Off": Turns this feature off.
This feature must be set by using the
handset.
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press {>}.
3
Scroll to "Set base unit" by pressing
{V} or {^}, then press {>}.
4
Scroll to "Interrupt tone" by
pressing {V} or {^}, then press {>}.
5
Press {V} or {^} repeatedly to select
the desired setting.
6
Press {Save}, then press {OFF}.