Table of Contents
Advertisement
Upholstery
The upholstery is made of two-ply polyester. The seat upholstery is fastened lengthways to the seat frame.
The upholstery can easily be removed from the frame by unscrewing the end caps. The backrest upholstery is
removed by loosening the screws of the push handle attachments and then pulling the upholstery upwards.
Wash seat and backrest upholstery according to the washing instructions on the product.
Rear wheel/castor, front fork attachment
Tyre/inner tube:
Spokes:
Wheel axles:
Ball bearings:
Handrims:
Front fork attachment: To achieve the best operating conditions, the attachments should be installed at the cor-
Brakes
The braking effect is dependent on the air pressure in the tyres. Encrusted dirt can have a negative effect
on the brake mechanism. Check the functioning of the brakes once a month.
In the event of adjustments, see point 7:4.
Washing the frame
It is important to keep the wheelchair clean, both for your own comfort and the longevity of the chair. It is
equipped with drainage holes which ensures that it is easy to wash and dry.
Clean the frame with a non-abrasive cleaning agent with a pH level between 5 and 9, or with a 70% disin-
fectant solution. Rinse and dry.
Touch-up paint
Touch-up paint is available for minor scratches and chips in all the frame colours available for Cross wheel
chairs.
Miscellaneous
If there is a fault in your wheelchair you should contact your dealer or Technical Aids Centre. Defective
wheelchairs should not be used. If your chair needs reconditioning or repair, only original parts from Etac or
components with equal quality, as specified in Cross diagrams, should be used. Etac will not be held respon-
sible for damage or injury caused by use of non-original parts.
(!) When necessary, lubricate moving parts/joints with bicycle oil or similar.
13 Care and maintenance
Check the tyre pressure (see side of tyre) at least once a month, also check the tread.
Loose spokes can lead to wheel wobble. Consult a cycle dealer or your Technical Aids
Centre if it is necessary to adjust the spokes.
Clean the wheel axles from hair and dirt as necessary.
Require no maintenance.
If a handrim should be damaged in such a way that it could lead to injury, it should be
replaced.
rect angle. Check also that the front forks are tightened according to instructions, see
point 6:4.
35
Advertisement
Table of Contents
