Adjusting The Paper Cassette For The Paper Width; How To Adjust The Paper Cassette For The Paper Width - Panasonic Panafax UF-6100 Operating Instructions Manual

Adjusting the Paper Cassette for the Paper Width

How to Adjust the Paper Cassette for the Paper Width

The factory default Paper Width setting for the Paper Cassette is on A4 size. To change the paper width to
Letter/Legal size, follow the steps below.
1
Paper Separation Clip
2
Paper
Width Guide
Max. Paper
Capacity Mark
3
1. If you forget to change the Recording Paper Size setting in Fax Parameter No. 23 when
NOTE
different paper is installed in the cassette, the unit will Stop printing after the 1st page of an
Incoming Fax and display a "PAPER SIZE MISMATCH" error. Then, the Recording Paper Size
setting automatically adjusts to the proper size and the unit resumes printing the Incoming Fax
from the 1st page.
1. Release the left Paper Separation Clip
latch.
2. Pull up the Paper Separation Clip to
remove it.
3. Reposition the Paper Separation Clip
into the LTR/LGL slot.
4. Swing the Paper Separation Clip
downward to latch it in place.
1. Load the paper into the Paper Cassette.
Slide the paper width guide to the left
until it lightly touches the stack of paper
without bending the paper. The paper
must fit squarely and firmly between the
Paper Width Guide and the right side of
tray. If it does not, the paper may feed
into the printer incorrectly resulting in a
paper jam.
Caution: Make sure that the paper is set
LTR
A4
LGL
2. Replace the Paper Cassette Cover to the
appropriate paper position (LTR, A4 or
LGL).
3. Slide the Paper Cassette into the
machine.
The Recording Paper Size setting of the Fax
Parameter No. 23 must match the paper
loaded in the cassette. If you change the
Recording Paper Size, please change the
setting accordingly. (See page 37)
under the metal Paper
Separation Clips and that it does
not exceed the Maximum Paper
Capacity Mark. You can load
about 250 sheets (75g/m²
weight). For paper specification,
see page 145.
21