Clearing Password Check And Bios Recovery - Acer ASPIRE 4333 Service Manual

Clearing Password Check and BIOS Recovery

This section provide you the standard operating procedures of clearing password and BIOS recovery for Acer
Aspire 4333/4733Z. Acer provides one Hardware Open Gap on the mainboard for clearing password check,
and one Hotkey for enabling BIOS Recovery.
Hardware Open Gap Description is as follows:
G2 / G3
Steps for Clearing BIOS Password Check
If users set BIOS Password (Supervisor Password and/or User Password) for a security reason, BIOS will ask
the password during systems POST or when systems enter to BIOS Setup menu. However, once it is
necessary to bypass the password check, users need to short the HW Gap to clear the password by the
following steps:
1. Power Off the system, and remove HDD, AC, Battery and DIMMs from the machine.
2. Open the Bottom Cover of the machine and locate the G2 and G3 jumpers.
3. Use an electric conductivity tool to short the two points of the HW Gap.
4. Plug in AC, keep the short condition on the HW Gap, and press Power Button to power on the system
until BIOS POST is finished. Then remove the tool from the HW Gap.
5. Restart system. Press F2 key to enter BIOS Setup menu.
6. If there is no Password request, BIOS Password is cleared. Otherwise, please follow the steps and try
again.
NOTE: These steps are only for clearing BIOS Password (Supervisor Password and User Password).
Chapter 5
Item Description
CMOS Jumper
Location
DIMM bay
133