Installing The Recording Paper; Installing The Paper Stacker - Panasonic KX-FT33HK Operating Instructions Manual

Installing the recording paper

1
Open the cover by pressing the cover open
button and install the recording paper roll.
incorrect
correct
If the paper is secured with glue or tape, cut
approximately 15 cm (6 inches) from the
beginning of the roll.
2
Insert the leading edge of the paper into the
opening above the thermal head and pull it out of
the unit.
Make sure that there is no slack in the paper
roll.
3
Close the cover securely by pushing down on
both corners.
Note:
Only use the included roll of paper or specified recording paper, or else the print quality may be affected
and/or excessive thermal head wear may occur.
To order recording paper, see page 5.
When the power cord is connected, everytime you close the cover a message will be printed. If the recording
paper is set to the wrong side, a message will not be printed. Install the paper correctly.

Installing the paper stacker

Install the paper stacker.
Setup
Cover open
button
Thermal head
Paper stacker
– 17 –