Table of Contents
Advertisement
Jams
Clearing a recording paper jam
If the unit does not eject any recording paper during reception or copying, the recording paper has jammed.
Remove the jammed paper as shown below.
1
Open the cover by pressing the cover open
button and remove the recording paper roll.
2
Replace the recording paper roll in the proper
direction, and pull the leading edge of the paper
approximately 10 cm (4 inches) out of the unit.
Make sure that there is no slack in the paper
roll.
3
Close the cover securely by pushing down on
both corners.
When you close the cover, do not push the
flaps down or a paper jam will occur.
4
Tear off the excess paper by pulling it towards
you.
Note:
When the power cord is connected, everytime you close the cover a message will be printed. If the recording
paper is set to the wrong side, a message will not be printed. Install the paper correctly.
62
Flaps
Cover open
button
Advertisement
Table of Contents
