Table of Contents
Advertisement
Quick Links
Automatic Control Switch
SPECIFICATIONS
Voltages ...............................................120 or 277VAC, 50/60Hz
Load Requirements
@120VAC, 50/60Hz ...........0-1300W ballast & incandescent
@277VAC, 50/60Hz .....................................0-3000W ballast
®
InteliSwitch
AS-100
120/277VAC
Santa Clara, CA 95050
Advertisement
Table of Contents
Related Manuals for wattstopper InteliSwitch AS-100
Summary of Contents for wattstopper InteliSwitch AS-100
- Page 1 ® InteliSwitch AS-100 Automatic Control Switch 120/277VAC SPECIFICATIONS Voltages ..........120 or 277VAC, 50/60Hz Load Requirements @120VAC, 50/60Hz ...0-1300W ballast & incandescent @277VAC, 50/60Hz ........0-3000W ballast Santa Clara, CA 95050...
- Page 2 DESCRIPTION ® The Watt Stopper InteliSwitch AS-100 is an automatic control switch that operates as both a manual and automatic control device. Manually, it allows users to control loads ON and OFF. Automatically, the AS-100 receives signals to turn loads ON and OFF from Watt Stopper lighting control panels, or other lighting control systems.
-
Page 3: Installation
2. Attach the switch to the wall by mounting it in the wall box with the two (2) mounting screws provided. 3. Install the cover plate. 4. Turn ON power to the switch and, if necessary, put it into Setup Mode to select options. www.wattstopper.com... -
Page 4: Master Switch
WIRING The ground terminal must be Wiring a single switch connected to ground for the AS-100 to a lighting control panel to function. Never connect the AS-100 to a power pack; always connect the AS-100 to a lighting control panel. Signal Only Ground No connection for... -
Page 5: Factory Settings
SETUP The AS-100 Automatic Control Switch comes factory preset and ready to install in conjunction with a lighting control panel. The default operation is manual-ON/ OFF along with automatic-OFF when signalled by the lighting control panel. If an audible beep warning or automatic-ON features are desired, use the following procedure: •... -
Page 6: Operation
OPERATION Manual ON and OFF control is always available by pressing the ON/OFF button. Automatic-OFF and Automatic Delayed-OFF are always enabled regardless of other Setup Mode options. When set for Automatic-ON mode (see SETUP section), the AS-100 turns ON the load when it receives the Automatic-ON signal from a Watt Stopper lighting control panel or other lighting control system. -
Page 7: Troubleshooting
+/- one-quarter of a second (see Operation section). 5. Check to make sure that the ground terminal is connected. The AS-100 will not operate properly without a ground connection. 6. If the AS-100 is still not functioning properly, call 800.879.8585 for technical support. www.wattstopper.com... -
Page 8: Ordering Information
* - W for white, I for ivory, A for light almond Cover Plates The Watt Stopper InteliSwitch AS-100 Automatic Control Switch fi ts behind industry standard decorator-style cover plates. Watt Stopper has both single- and double-gang switch plates available in most confi gurations. Consult the Watt Stopper product selection guide or your distributor for more information.