Whirlpool FSCR12420 Health & Safety, Use & Care And Installation Manual page 35

If your washing machine model has no emergency
drain hose:
Slowly turn the filter counterclockwise until water
flows out . Let the water flow out, without removing
the filter .
When the container is full, close the water filter by
turning it in clockwise . Empty the container . Repeat
this procedure until all the water has drained .
4.
Remove filter: Lay a cotton cloth beneath the
water filter, which can absorb a small amount of
rest water . Then remove the water filter by turning
it out anticlockwise .
5.
Clean the water filter: remove residues in the
filter and clean it under running water .
6.
Insert the water filter and reinstall the plinth:
Reinsert the water filter again by turning it in
clockwise direction . Make sure to turn it in as far
as it goes; the filter handle must be in vertical
position . To test water tightness of the water
filter, you can pour about 1 liter of water into the
detergent dispenser .
Then reinstall the plinth .
2
1
EN
35