Table of Contents
Advertisement
LAN-SAFE FIREWALL
2. Punch down the telephone line cable to the 2-pair
110 connector. The middle two terminals are Tip
and Ring.
3. Connect a standard LAN jumper cable from
the NIC in the PC to the 8-pin RJ-45 connector,
labeled "Computer."
4. Connect the telco line cable from the modem
to the 6-pin RJ-11 connector.
5. Slide the switch to the inside of the PC board
and place a modem call. The LED should turn
on. This indicates that the secure device has
been disconnected from the LAN. Check it.
If the LED does not come on, check the
modem cable connections.
6. Hang up the modem and wait for the LAN
connection to re-establish itself.
7. To use the Enhanced model functions of the
MC172A or MC173A, slide the switch to the
outside of the PC board and install the software
as described in Chapter 4.
12
Advertisement
Table of Contents
