Power System - Stairmaster SC 916 Technical Manual

Power System

The Freeclimber is self-powered (cordless) with
a rechargeable battery back-up. Unless using the
TS-1, or TSE-1 touchscreen console, the
Freeclimber can be operated without plugging in
the external power supply. If using previously
mentioned consoles, the machine must be
connected to power using the adapter.
If, however, the console flickers during operation
or the console display does not light up while
using the machine, then use the external power
supply to recharge the battery back-up. The
external power supply is supplied with the unit
and plugs into a standard 115 volt, 15 amp
outlet, or a 220 volt, 10 amp outlet. (All major
voltage plugs are available.) The plug-in for the
external power supply is located in the front of
the machine at the base.
Plug the wall pack external power supply into the
connector and charge the battery for
approximately 24 hours and then recheck it. It is
okay to use the machine while the external
power supply is connected. The console will
power on as user starts to move the pedals of
the machine, and will stay lit for up to 60 seconds
in pause mode. The console will power off after
60 seconds of stopping exercise. The console
will power on and remain powered whenever the
external power supply is connected.
Side View Wiring Specifics
Last revised 10/19/15