Yamaha 2011 WaveRunner FZR Owner's/Operator's Manual page 47

sounds intermittently. At the same time, the
maximum engine speed is limited.
If the oil pressure warning is activated, imme-
diately reduce the engine speed, return to
shore, and then check the engine oil level.
(See page 53 for information on checking the
engine oil level.) If the oil level is sufficient,
have a Yamaha dealer check the watercraft.
TIP:
Push the "Hour Volt" button to stop the buzz-
er.
EJU37303
Engine overheat warning
If the engine temperature rises significantly,
the engine overheat warning indicator and the
"WARNING" indicator light blink, and the
buzzer sounds intermittently. Then, the en-
gine overheat warning indicator and the
"WARNING" indicator light stop blinking and
remain on, and the buzzer sounds continu-
ously. At the same time, the maximum engine
speed is limited.
Instrument operation
If the engine overheat warning is activated,
immediately reduce the engine speed, return
to shore, and then make sure that water is be-
ing discharged from the port (left) cooling wa-
ter pilot outlet while the engine is running. If
there is no discharge of water, stop the en-
gine, and then check the jet intake for clog-
ging. (See page 95 for information on the jet
intake.) NOTICE: If you cannot locate and
correct the cause of the overheating, con-
sult a Yamaha dealer. Continuing to oper-
ate at higher speeds could result in severe
engine damage.
[ECJ00041]
TIP:
Push the "Hour Volt" button to stop the buzz-
er.
EJU37312
Check engine warning
If a sensor malfunction or a short circuit is de-
tected, the check engine warning indicator
and the "WARNING" indicator light blink, and
the buzzer sounds intermittently.
42