Gas Conversion - Nordmende CSG50LPGWH Operating And Installation Instructions

3. INSTALLATION AND PREPARATIONS FOR USE
• The appliance is adjusted for 230V 50Hz electricity. If the mains electricity is different contact
your authorized service
• The supply cord should be kept away from hot parts of appliance. Otherwise, the cord may be
damaged, causing short circuit.
• The manufacturer declares that it has no responsibility against any kind of damages and losses
that are caused by improper connections that are performed by unauthorized people

3.6 Gas conversion

Caution : The following procedures must be undertaken by authorized service people.
Your appliance is adjusted to be operated with LPG gas. The gas burners can be adapted to different
types of gas, by replacing the corresponding injectors and adjusting minimum flame length suitable
to the gas in use. For this purpose, following steps should be performed
Changing injectors:
Hob Burners :
• Cut off the main gas supply and unplug from the electric mains
• Remove the burner cap and the adapter(Figure 9).
• Unscrew the injectors. For this, use a 7mm spanner(Figure 10).
• Replace the injector with the ones from the gas conversion kit, with corresponding diameters
suitable to the type of gas that is going to be used, according to the information chart (which is
also supplied in the gas conversion kit).
.
L N
Figure 8
.
11
.
: