Setting Down, Transportation And Storage - Miele HS16 Operating Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 27
en
During vacuuming
 When vacuuming, pull the cleaner be-
hind you on its wheels. You can stand
it upright for vacuuming stairs and
curtains etc.
When vacuuming, in particular
fine dust, e.g. sawdust, sand, plaster,
flour, talcum powder etc., electro-
static charges build up naturally. Un-
der certain conditions these charges
will be released. To avoid the un-
pleasant effects of these discharges,
a metal inlay has been incorporated
into the underside of the handle.
Please make sure that you keep your
hand in constant contact with this
metal strip during vacuuming. If your
vacuum cleaner is fitted with an Eco
Comfort handle, make sure you hold
it by the bowed section as this is
where this metal strip is incorpor-
ated. (dia. 18, 19 + 20)
Interrupting operation (dia. 16)
(for models with radio controls on the
handle)
The vacuum cleaner can be paused for
short breaks whilst vacuuming.
 Press the Standby button  on the
handle.
The Standby button is designed
to pause the vacuum cleaner for
short periods of time whilst vacuum-
ing. Do not leave the vacuum cleaner
in Standby mode for long periods.
This can cause overheating and
damage.
An LED will indicate each time a button
is pressed on the handle.
42
At the end of the pause you can do one
of the following:
 Press the Standby button  again to
switch the vacuum cleaner back on at
the setting you were using before
pausing it.
 Press the + button to switch the va-
cuum cleaner back on using the
highest power setting.
 Press the - button to switch the va-
cuum cleaner back on using the low-
est power setting.
Setting down, transportation
and storage
Park System for pauses during vacu-
uming (dia. 21)
The Park System allows you to conveni-
ently park the suction tube and floor-
head during pauses.
 Slot the floorhead or floorbrush into
the parking attachment on the va-
cuum cleaner.
If your vacuum cleaner is on a slop-
ing surface, e.g. a ramp, retract the
telescopic tube fully.
Park System for storage (dia. 22)
Always disconnect the vacuum
cleaner from the power supply when
you have finished using it. Switch it
off at the wall socket and unplug it.
 Stand the vacuum cleaner upright.
Retract the telescopic tube fully so
that the vacuum cleaner takes up less
room for storage.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Blizzard cx1

Table of Contents