Bosch GST 75 BE Professiona Original Instructions Manual page 18

OBJ_BUCH-171-004.book Page 18 Thursday, June 17, 2010 11:43 AM
18 | English
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Products sold in GB only: Your product is fit-
ted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to
BS 1362).
If the plug is not suitable for your socket out-
lets, it should be cut off and an appropriate
plug fitted in its place by an authorised cus-
tomer service agent. The replacement plug
should have the same fuse rating as the orig-
inal plug.
The severed plug must be disposed of to
avoid a possible shock hazard and should
never be inserted into a mains socket else-
where.
Products sold in AUS and NZ only: Use a re-
sidual current device (RCD) with a rated re-
sidual current of 30 mA or less.
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Intended Use
The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.
1 609 929 W89 | (17.6.10)
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Lock-on button for On/Off switch
2 On/Off switch
3 Allen key
4 Thumbwheel for stroke rate preselection
5 Vacuum connection
6 Base plate
7 Adjusting lever for orbital action
8 Switch for sawdust blowing device
9 Guide roller
10 Saw blade*
11 Contact protector
12 Dust cover for vacuuming*
13 Handle (insulated gripping surface)
14 Stroke rod
15 SDS clamping lever for saw blade release
16 Vacuum hose*
17 Extraction adapter*
18 Splinter guard*
19 Scale for mitre angle
20 Screw
21 Angle gauge**
22 Bolt hole
23 Positioning pin/mark
24 Lead for the parallel guide
25 Locking screw for parallel guide*
26 Parallel guide with circle cutter*
27 Centring tip of the parallel guide*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
**Commercially available (not included in the deliv-
ery scope)
Bosch Power Tools