Yamaha DTXPRESS IV Owner's Manual page 39

After an triggering event occurs from the pad that is assigned in
the "Frm=" setting, the pad assigned in the upper half of the dis-
play will not sound for a certain length of time unless the input
level is greater than the value set here. Larger values will require
a greater input level in order to produce a trigger event.
A "Frm=56" setting assigns both trigger input jacks 5 and 6.
TRG8 CopyToInput (Trigger Setup Copy)
TRG8 ~ƒsnare
"CopyToInput=~2‚
This function allows you to copy all data settings in pages [TRG2
Type (Pad Type)] through [TRG7 RejLvl (Specified Rejection
Level)] to another input jack.
CAUTION
When the Trigger Setup Copy operation is car-
ried out, the Trigger Setup data will be replaced
with the settings of the copy source.
Operation
1. Hit a pad to select the copy source (input jack) from
which the data will be copied.
Rotate the jog dial and assign the copy destination (input
jack).
Copy source (input jack)
TRG8~ ƒsnare
"CopyToInput=~2‚
Copy destination (input jack)
2. Press the [SAVE/ENTER] button. A prompt appears ask-
ing confirmation of the Copy operation.
Input~Copy~to~2
~Are~you~sure~?
3. Press the [SAVE/ENTER] button to actually execute the
Copy operation.
* To cancel the Copy operation, press any button except for the
[SAVE/ENTER] and [SHIFT] buttons (the jog dial can also be
used to cancel the operation).
The following display appears after the Copy operation is
complete.
~~~Completed!
8 Trigger Setup Edit
IV
DTXPRESS Owner's Manual
39