Ricoh MP C306 User Manual page 111

Hide thumbs Also See for MP C306:
Table of Contents

Advertisement

18.
Press [Change] or [Browse Network], and then specify the folder.
To specify a folder, you can either enter the path manually or locate the folder by browsing the
network.
19.
Press [Connection Test] to check the path is set correctly.
20.
Press [Exit].
If the connection test fails, check the settings, and then try again.
21.
Press [OK].
22.
Press [User Tools] (
23.
Press [Home] (
) at the bottom of the screen in the center.
Locating the SMB folder manually
1.
Press [Change] under "Path".
2.
Enter the path where the folder is located.
For example: if the name of the destination computer is "User", and the folder name is "Share", the
path will be \\User\Share.
If the network does not allow automatic obtaining of IP addresses, include the destination
computer's IP address in the path. For example: if the IP address of the destination computer is
"192.168.0.191", and the folder name is "Share", the path will be \\192.168.0.191\Share.
3.
Press [OK].
If the format of the entered path is not correct, a message appears. Press [Exit], and then enter the
path again.
Locating the SMB folder using Browse Network
1.
Press [Browse Network].
The client computers sharing the same network as the machine appear.
Network display only lists client computers you are authorized to access.
2.
Select the group that contains the destination computer.
3.
Select the computer name of the destination computer.
Shared folders under it appear.
You can press [Up One Level] to switch between levels.
4.
Select the folder you want to register.
5.
Press [OK].
) on the top right of the screen.
Basic Procedure When Using Scan to Folder
109

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mp c406

Table of Contents