Twin-Star International 23CM100 Assembly Instructions Manual page 5

Front Molding Top
GG
Front
Molding
Right
9. Locate the three front molding pieces
( EE, FF, GG) and four dowels. With the
three molding pieces face down on a clean
smooth flat surface. Insert dowels into the
two holes on the side molding pieces
(FF, GG). Carefully slide the left (FF) and
right (GG) side molding pieces into place
using the dowels. Locate flat metal bracket
( ) and place into spaces in back of molding
pieces. Attach bracket to molding pieces
using small wood screws (T).
CAREFUL NOT TO OVER TIGHTEN.
E-4
EE
Front
FF
Molding
Left
N
T
S
M
L
10. Set completed front molding assembly
against front of fireplace. Fit over the
molding detail attached to the center
panel, and align with the sides of the fire-
place opening. From the back of unit insert
10 bolt (L) w/washer (M) into the predrilled
holes and tighten.
BE CAREFUL NOT TO OVER TIGHTEN.