Troubleshooting - Philips HTS3538 User Manual

Main unit
•
Power supply:
•
Europe/China/Russia/India: 220-240V~,
50 Hz
•
Latin America/Asia Pacifi c: 110-240V~,
50-60 Hz
•
Power consumption: 110 W
•
Standby power consumption: ≤ 0.9 W
•
Dimensions (WxHxD): 360 x 58 x 325 mm
•
Weight: 2.52 kg
Subwoofer
•
Output power: 100 W RMS (30% THD)
•
Impedance: 4 ohm
•
Speaker drivers: 133 mm (5.25") woofer
•
Dimensions (WxHxD): 160 x 267.5 x 265
mm
•
Weight: 2.55 kg
Speakers
Centre speaker:
•
Output power: 100 W RMS (30% THD)
•
Speaker impedance: 4 ohm
•
Speaker drivers: 1 x 63.5 mm (2.5") woofer
•
Dimensions (WxHxD): 160 x 85 x 95 mm
•
Weight: 0.37 kg
Front/Rear speaker:
•
Output power: 4 x 100 W RMS (30% THD)
•
Speaker impedance: 4 ohm
•
Speaker drivers: 1 x 76.2 mm (3") twin driver
•
Dimensions (WxHxD):
•
Speakers: 85 x 160 x 95mm
•
Tall speakers: 240 x 1007 x 240 mm
•
Weight:
•
Speakers: 0.35 kg/each
•
Tall speakers: 1.57 kg/each
Remote control batteries
•
2 x AAA-R03-1.5 V
Laser
•
Type: Semiconductor laser GaAIAs (CD)
•
Wave length: 645 - 665 nm (DVD), 770 - 800
nm (CD)
•
Output power: 6 mW (DVD), 7 mW (VCD/
CD)
•
Beam divergence: 60 degrees.
EN
18
8

Troubleshooting

Warning
•
Risk of electric shock. Never remove the casing
of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, get support at www.philips.
com/support.
Main unit
The buttons on the home theatre do not work.
•
Disconnect the home theatre from the
power supply for a few minutes, then
reconnect.
Picture
No picture.
•
Make sure that the TV is switched to the
correct source for the home theatre.
•
If this happens when you change the
TV system, press
compartment, and then 439 on the remote
control to restore the default TV system.
No picture on a TV connected through HDMI.
•
Make sure that the HDMI cable is not faulty. If
it is faulty, replace it with a new cable.
•
If this happens when you change the HDMI
video resolution, press
compartment, and then 304 on the remote
control to restore the default setting.
•
Wait for 10 seconds for auto recovery, or
change the HDMI video setting .
Disc does not play high-def nition video.
•
Make sure that the disc contains high-
defi nition video.
•
Make sure that the TV supports high-
defi nition video.
•
Use an HDMI cable to connect to the TV.
to open the disc
to open the disc