To Preset Channels (Search) - Palsonic 5120B Owner's Manual

OPERATION
Tuning in (continued)
Use the SEARCH function if desired channels can not be preset with the ASM or if you would like
to preset channels to specific position numbers one by one.
It is convenient to set the channel numbers to the same position numbers using SEARCH and SKIP
functions.

To preset channels (SEARCH)

SEARCH
If ASM can not preset the desired channels, or you want to preset the desired channels one by one with
the preferred channel numbers, please make use of SEARCH.
1. Enter into PRESET menu, press the POS+/- button to select and
2. Press the POS+/- button to select SEARCH. Press the VOL+ button to
Note: you can also make use of BAND selection to quicken the
searching process in your desired band. Press the POS+/- button to
select BAND, pressing the VOL+/- button moves the band to the next
one in the sequence below.
3.When you want to store another channel at another position, repeat steps 1 & 2 above.
Note: After SEARCH, to exit the PRESET menu, press the RECALL button, or press PRESET
button or MENU button repeatedly until OSD disappears.
highlight POS. Press the VOL+/- button to select a
desired position number (from 0-255).
Note: you can also press 0-9 button to select a
one-digit position number.
Press --/--- button and number buttons to select a
two-digit or three-digit position number.
search channels from current channel to higher
channel. Press the VOL- button to search channels
from current channel to lower channel. When a
channel is located, the searching stops, this channel
is then memorized with the preset position number.
V-L V-H UHF
8
PRESET
POS
4
SKIP ON
BAND V-L
FINE
AFT OFF
SEARCH
ASM
S-RCV OFF
PRESET
POS
4
SKIP ON
BAND V-L
FINE
AFT OFF
SEARCH
ASM
S-RCV OFF
PRESET
POS 20
SKIP OFF
BAND V-H
FINE
AFT OFF
SEARCH
ASM
S-RCV OFF