Table of Contents
Advertisement
TELEVISION MODE
Television mode
The TEV-501 is equipped with an inter-
nal television receiver and a 44-chan-
nel memory.
Television channels are received using
the TEV-501's rod aerial or an external
aerial.
The aerial must be connected to the RF
IN L connection.
If you want to use an external aerial in-
stead, you can protect the plug of the
disconnected rod aerial from becoming
damaged by inserting it into the park-
ing hole.
Configuring the television
system
In order for television reception to work,
the TEV-501 must be configured for the
television system of the country in which
you are located.
There are two television standards in
Europe (PAL and SECAM) and the TEV-
501 supports both. You can switch be-
tween PAL and SECAM.
For the PAL television standard,
slide the GB/DK L 7switch to the
left.
For the SECAM television standard,
slide the GB/DK L 7 switch to the
right.
24
Tuning into a station
Switch on the TEV-501 by pressing
the POWER = button.
If need be, switch to television
mode using the TV/AV 1 button.
Use the CH
ton to select the channel memory
location in which you want to store
a station.
Press the PRESET button 3.
The frequency band is displayed sym-
bolically at the bottom of the display. The
frequency range U, VL or VH is dis-
played on the left. Next to it is the
number of the set memory location.
Press the TV/AV 1 button repeat-
edly until the required frequency
range U, VL or VH is shown.
To search for a station in an up-
wards direction, press the PRESET
4 button.
To search for a station in a down-
wards direction, press the PRESET
2 button.
A station is then searched for in the
specified direction. As soon as one is
found, the station searching procedure
stops.
Note:
To optimise reception, you can tilt
the rod aerial in various directions.
Try finding the best position.
5 or CH
6 but-
Advertisement
Table of Contents
