SERVICE AND ADJUSTMENTS
CAUTION: TO AVOID SERIOUS INJURY, BEFORE
PERFORMING ANY SERVICE OR ADJUSTMENTS:
1. Release control bar and stop engine.
2. Make sure the blade and all moving parts
have completely stopped.
3. Disconnect spark plug wire from spark
plug and place where it cannot come in
contact with plug.
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation
section of this manual.
The rear deflector, attached between the rear wheels of
your mower, is provided to minimize the possibility that
objects will be thrown out of the rear of the mower into the
operator's mowing position. Replace the rear deflector if
it becomes damaged.
If your mower does not operate properly due to suspected
drive belt problems, take your mower to a qualified service
center for repair and/or ad just ment.
TO ADJUST HANDLE (See Fig. 22)
The upper handle may be adjusted to three (3) different
1. Move operator presence control bar forward to unlock
2. Lift handle to desired adjustment position.
Maintenance, re pair, or re place ment of the emission con trol
de vic es and sys tems, which are be ing done at the cus tom-
ers expense, may be performed by any non-road engine
repair es tab lish ment or individual. Warranty repairs must
be performed by an authorized engine man u fac tur er's
Your engine speed has been factory set.
Your carburetor is not adjustable.
IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR,
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.
OVER SPEED ING THE ENGINE ABOVE THE FACTORY HIGH
SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,
CONTACT YOUR NEAREST HUSQVARNA OR OTHER
AUTHORIZED SER VICE CEN TER, WHICH HAS PROPER
EQUIP MENT AND EXPERIENCE TO MAKE ANY NEC ES SARY