Configuring The Technical Settings - Ariston E8.5064 Operating Instructions Manual

confi guring the settings
CONFIGURING THE TECHNICIAN'S PARAMETERS
Open the door, turn the control
and select the "EXPERT" fi eld and the "INSTALLATION" fi eld, then:
• press the programming button
• set the "CODE- -NO" at "0000" (by pressing the button 4 times);
• turn the control to select the "BUS- -ID HS" parameter;
• press the programming button
PARAMETER
BUS- -ID 1
BUS- -ID 1
TURN THE CONTROL AND SELECT THE "BUS- -ID HS 2" PARAMETER
BUS- -ID 2
BUS- -ID 2
Ruotare LA MANOPOLA SELEZIONARE IL PARAMETRO "TIMER MASTER"
TIMER MASTER
TIMER MASTER
;
(red LED on);
DISPLAY SCREEN
0 1
PRESS THE PROGRAMMING BUTTON "
PRESS THE PROGRAMMING BUTTON "
0 2
PRESS THE PROGRAMMING BUTTON "
PRESS THE PROGRAMMING BUTTON "
0 1
FIGURE DESCRIPTION
Turn the control and set at "01" for a combi-
01
ned heating circuit (or 00 for a direct circuit).
"
" (
RED LED ON)
Turn the control and set at 02 for a combined
heating circuit (if you see four dashes on
02
the screen, check the VFAS delivery probe of
circuit 2 is connected)
"
" (
RED LED ON)
Turn the control and set at 01. All the periphe-
01
rals are now set at the same date and time as
the E8 control unit.
GB
49