Table of Contents
Advertisement
Troubleshooting Guide
No power / won't go into programming mode:
• Check Red wire connection and fuse. Make sure INTERFACE is connected to switched +12volts, not constant +12volts.
• Make sure vehicle ignition is on.
The INTERFACE controls the stereo immediately without pressing any buttons on the steering wheel:
• During programming, press the buttons on the steering wheel firmly until the left LED turns off. Releasing the button too early
will cause the INTERFACE to send out a signal even when no buttons are pressed.
The INTERFACE controls the radio whenever the steering wheel is turned (mostly late 80's early 90's Honda/Acura).
• Program the INTERFACE for version #11.
When ever I program a new button the previous button does not work.
• You must program all buttons during programming. If you try to program another button, all previous button will be erased. You
will have to relearn all previous buttons again.
We are always looking for new vehicle information. If you've successfully completed the installation on a vehicle with
steering wheel controls, and the vehicle is not listed in these instructions or on our Website, contact us at
techsupport@pac-audio.com so that we may add the information to the instructions.
8
Working on a new or unlisted vehicle?
Pacific Accessory Corporation
1502 S. Santa Fe St. • Santa Ana, CA 92705
techsupport@pac-audio.com • www.pac-audio.com
Copyright 2005 Pacific Accessory Corporation. Content subject to change without notice.
Hide quick links:
Advertisement
Table of Contents
