Active Mute Groups - AMX ALR-AEC-8 ALERO Instruction Manual

Configuration

Active Mute Groups

The Microphone mute groups are shown at the bottom of the Signal Mixing page. The microphones can be placed in five different
mute-groups. Each of these groups may be muted by setting the corresponding pin of connection 6 shown in the table on page 4
to ground. An indicator shows the state of each of the five mute groups; muted (active) / unmuted (not active), as well as a
selection matrix for assigning microphones to the different groups. Note that one microphone can be placed into several groups.
The microphone is muted as long as any mute group it is assigned to is active (muted).
Configuration of Mute Groups.
FIG. 29
14
Alero 8-Channel Microphone Mixer Instruction Manual