Table of Contents
Advertisement
Connect Power
1.
Connect the power supply using the male two-pin Phoenix screw down plug. Refer to Power Supply on page 5 for details on
the power supply.
2.
Secure the plug terminals to the receptacle on the Alero backplate.
3.
Plug the power supply into the wall outlet using the cord included with the power supply. Alero will power on automatically.
12-Volt Power Connection
FIG. 17
Connect Audio Conference Equipment
Prepare wire ends by cutting 1/4" of the insulation off of the end of the wires. Insert the stripped ends into the Phoenix style secure
screw terminals (FIG. 18). Refer to the wire guide on the Alero rear panel for each connector type.
+ = Positive
G = Ground
- = Neutral
1.
If using an audio conference device, connect the input and output channels to the Alero rear panel Line In and Line Out.
Insert
Stripped
Wire Ends
Audio Conference Device Connections
FIG. 18
2.
The Alero USB port is used to pass audio to local equipment used to make conference calls (i.e., a local room PC being used to
make Skype calls). If using the USB port for Audio output, connect the cable to the USB port (FIG. 19).
Serial Audio Conference Device Connections
FIG. 19
Connect Video Conference Equipment
1.
If using a video conference device, connect the audio inputs/outputs to the Alero VC connection IN/OUT while passing the
Video signal to the Enova DVX All-In-One Presentation Switcher or other switching equipment. The audio signal will then pass
to the conference room switcher (i.e., DVX) for volume control.
Video Conference Device Connections
FIG. 20
Alero 8-Channel Microphone Mixer Instruction Manual
Screw down
terminals
Installation
Back Panel Wire Guide
Insert Phoenix
style male
connector into
back panel
connections
8
Advertisement
Table of Contents
