Lamp Replacement - Sanyo PLC-XK2200 Service Manual

Lamp Replacement

Lamp replacement
WARNING:
- For continued safety, replace with a lamp assembly of the same
type.
- Allow the projector to cool for at least 45 minutes before you open the
lamp cover. The inside of the projector can become very hot.
- Do not drop the lamp module or touch the glass bulb! The glass can
shatter and cause injury.
Follow these steps to replace the lamp.
1
Unplug the AC power cord. Let the projector cool for at
least 45 minutes.
2
Loosen the screw and open the lamp cover.
3
Loosen the three (3) screws that secure the lamp. Lift
the lamp out of the projector by using the handles.
4
Replace the lamp with a new one and secure the three
(3) screws. Make sure that the lamp is set properly.
Close the lamp cover and secure the screw.
5
Connect the AC power cord to the projector and turn
on the projector.
6
Reset the Lamp Replace Counter.
Refer to the next page for details.
WARNING : tuRN OFF tHe uV LAMP BeFORe OPeNING tHe LAMP COVeR.
CAutION
Allow a projector to cool for at least 45 minutes
before you open the Lamp Cover. The inside of the
projector can become very hot.
CAutION
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be
broken.
If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that the
lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover
gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes
or mouth, seek medical advice immediately.
uSe uV RAdIAtION eYe ANd SKIN PROteCtION duRING SeRVICING.
ORdeR RePLACeMeNt LAMP
type No.
Service Parts No.
Lamp Cover
Screw
Lamp
CAutION
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass bulb!
The glass can shatter and may cause injury.
-9-
POA-LMP142
610 349 7518
Screw
Handles
Screw
Screw